26
Maintenance
5 Rinse the filter with clean water and shake it to remove
excess water.
6
Fig. 29
Let it dry in a cool, dry place, avoiding direct sunlight.
7 Once dry, reinsert the filter into the indoor unit.
4.3 Cleaning Your Louver
Only use a soft, dry cloth to wipe the unit clean.
If the louver is especially dirty, you can remove it and
wash it with water.
1 Press and hold MODE and SWING buttons on the
remote controller together for one second, the
deflector will open for a certain angle.
2 Hold the louver and remove it as shown below.
3
a
b
c
d
b
c
Fig. 30
Wash it with water and dry it in a cool,dry place.
4 Reinstall the louver, connect the power again, and this
will reset the louver.
4.4 Cleaning the outdoor unit
If the battery in the outdoor unit is clogged, remove the
leaves and debris and then remove the dust with a jet of
air or water.
Outdoor unit
battery
Fig. 31
Remove the louver
from left side
Release the left
side lock block
Release the middle lock
block
Remove the right side
small cover
To Next Page
Loading...
Need help?
General
