EVAC-500 Voice Alarm & Evacuation System Operation Manual
36 / 42
（1） “Paging -01 group -01：
1) “Paging-01” Indicates that the currently listed group information is a microphone at address 01.
2) “group-01” It's group 01, but it can also be 02 or 03. The range is: 01 ~ 12.
（2） “host 01： 01，02，04，05，06； host 02： 01，02，03，05，06”：Indicates that some partitions contain the
host (the system defaults to - host 01, and the user cannot change).
Except the partition 3 all partitions and extension of the host 01 all partitions except the partition 4 (extended host
number from 02, the user can not change), that is, the user in the address of 01 if you use a microphone on grouping
mode, the elected group 01 paging is equivalent to choose the host and at the same time extend the host 01 each five
partitions paging.
Note：
① After the modification is completed, please click "Application", otherwise your Settings will not be able to
complete your expected function on the corresponding device;
② Please refer to the above described above "when configured with the evac-500sft configuration as shown
below".
6.3.5. Fire Alarm Rules Configuration
1. Set fire alarm rules;
Set contact output partition and connect relay status;
“Fire mode”：
Above pic.：
① users can choose from a way:
To Next Page
Loading...