CNC-Step High-Z T-Series - Installing Accessories; Initial Start-Up

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 52
Support: +49 (0)2831/91021-50
15.02.2014
6.3.3 Ins t a lling A cc e ssori e s
HINT:
The equipment installation is carried out according to the specifications of the
accessories associated operating and assembly instructions.
WARNING:
Risk of injury due to improperly mounted accessories!
Improperly mounted accessories can lead to uncontrolled falling or throwing out
during operation and cause serious injury to skin and eyes.
• Mount accessories professionally according to the safety regulations.
Install milling motor
Personnel:
• Specialist personnel
Fig. 25: Tool holder with milling
1
Tool, for example milling motor with 43mm neck Euro
(Fig. 25/1) insert in the tool holder (Fig. 25/2) on the Z
carriage.
2
Tighten screw (Fig. 25/3) lightly until a clamping is done
3
Check milling motor for tightness in the accessory holder.
HINT:
Property damage caused by excessive tightening!
When excessive tightening the screw for mounting the milling motor, the main
bearing of the cutter motor may be damaged.
• Never tighten the screw (Fig. 25/2) for fixing the milling motor, excessively.
Only use the short side of an allen key for manual tightening!
6.4 Initial start-up
2
1
3