CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Support: +49 (0)2831/91021-50
Danger:
Risk of death due to stored voltage!
Electronic charges could be stored in electric components that still exist after
switching off and disconnecting from power-supply. Contact with these components
can lead to severe injury or even death.
• Before starting work disconnect mentioned components from power-supply.
Wait 10 minutes, in order to assure that the internal capacitors discharge
completely.
2.2.2 Dange r s by me c h a nics
Rotating tools
WARNING:
Risk of injury from rotating tools!
Clamped tools such as milling spindles can lead to severe personal injury or
material damage.
• Before the start of any work, ensure that all covers and protective devices are
correctly installed and function correctly.
• Never touch moving tool during operating process!
• Before exchanging tools, always pull power plug of the milling motor or turn
off the machine and secure against restarting.
WARNING:
Risk of injury by axis motion!
Collision by people with components of the machine (Y-bridge, Units, turntable with
work piece, tools) can cause severe injuries.
• Body parts are kept away from moving components and axis limit switches.
• Do not reach into gaps between trapezoidal screws and adjacent
components.
• Do not reach into gaps between unit and Y-bridge.
• Only work on the machine when it is idle.
• Only work with personal safety equipment.
To Next Page
Loading...
