CNC-Step High-Z T-Series - Activities after Use; Emergency Shutdown

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 59
Support: +49 (0)2831/91021-50
15.02.2014
7.6 Activities after use
Personnel:
• Operator
Safety equipment:
• protective clothing
• Safety shoes
• protective gloves
1.
Turning off the machine.
ATTENTION:
Risk of injury by chips!
Chips can be sharp and cause deep lacerations.
• Always wear protective gloves when removing chips.
2.
Clean the machine (see chapter 8.4.1).
7.7 Emergency Shutdown
In hazardous situations, movements of components must be stopped as soon as possible and the
power supply must be switched off.
Stopping in an emergency
1
Immediately activate emergency stop by emergency stop device.
2
If there is no danger for your health, remove persons from the danger zone.
3
If necessary, initiate first aid measures.
4
Call Fire department and / or ambulance service.
5
Inform the responsible person on site.
6
Turn the machine off and secure it against being switched on again.
7
Keep access routes for emergency vehicles free.
8
Instruct rescue vehicles.