CNC-Step High-Z T-Series - Page 65

Operating Instructions
High-Z T-Series
CNC-STEP GmbH & Co. KG ▪ Siemensstrasse 13-15 ▪ 47608 Geldern ▪ Germany
Page 65
Support: +49 (0)2831/91021-50
15.02.2014
Oil linear guides
Personnel:
• Qualified personnel
Safety equipment:
• protective clothing
• Safety shoes
• Chemical-resistant gloves
Fig. 28: linear guides of the X-and
Z-axis
1
2
Switch off the machine and secure against re-start.
Grease the linear guides of the X-axis (Fig. 28/1), the Z-axis
(Fig. 28/2) well using a low-friction grease wetted cloth DIN
61650 or alternatively apply the fat with a suitable brush.
Fig. 29: Cover Y-axis
2
Loosen and remove the four screws (Fig. 29/2).
3
Remove the cover (Fig. 29/1) on the Y-axis.
Fig. 30: Linear guide the Y-axis
4
Grease the linear guides of the X-axis (Fig. 30/1) well using
low-friction grease soaked cloth DIN 61650 or alternatively
apply the grease with a suitable brush.
1
2
2
2
1
1