GRMON3-UM
June 2019, Version 3.1.0
167 www.cobham.com/gaisler
67. mil - syntax
mil - MIL-STD-1553B Interface commands
SYNOPSIS
mil ?subcommand? ?args...?
DESCRIPTION
mil active bus device
Select which device to control and which bus to use for mil put and mil get.
mil status
Display core status
mil bcx addr ?count?
Print BC descriptor contents and result values
mil bmx addr ?count?
Print BM log entries from the given memory address
mil bmlog ?count? ?logaddr?
Print the latest entries from the currently running BM log
mil buf ?bufaddr? ?coreaddr?
Set address of temporary buffer for transfer commands
mil bufmode ?mode?
Select if the temporary buffer should be kept or restored. Valid mode-values are 'keep' or 'restore'
mil get rtaddr subaddr count
Perform an RT-to-BC transfer and display the result
mil getm rtaddr subaddr count memaddr
Perform an RT-to-BC transfer and store resulting data at memaddr
mil put rtaddr subaddr count word0 ?... word31?
Perform an BC-to-RT transfer
mil putm rtaddr subaddr count memaddr
Perform an BC-to-RT transfer of data located at memaddr
mil halt
Stop the core and store the state for resuming later.
mil resume
Resume operation with state stored earlier by the mil halt command.
mil lbtest rt
mil lbtest bc
Runs RT- or BC-part of loopback test
To Next Page
Loading...