COBHAM GRMON3 - Command Index

GRMON3-UM
June 2019, Version 3.1.0
83 www.cobham.com/gaisler
Appendix A. Command index
This section lists all documented commands available in GRMON3.
Table A.1. GRMON command oveview
Command
Name
Description
about Show information about GRMON
ahb Print AHB transfer entries in the trace buffer
amem Asynchronous bus read
attach Stop execution and attach GRMON to processor again
at Print AHB transfer entries in the trace buffer
batch Execute batch script
bdump Dump memory to a file
bload Load a binary file
bp Add, delete or list breakpoints
bt Print backtrace
cctrl Display or set cache control register
cont Continue execution
cpu Enable, disable CPU or select current active cpu
dcache Show, enable or disable data cache
dccfg Display or set data cache configuration register
dcom Print or clear debug link statistics
ddr2cfg1 Show or set the reset value of the memory register
ddr2cfg2 Show or set the reset value of the memory register
ddr2cfg3 Show or set the reset value of the memory register
ddr2cfg4 Show or set the reset value of the memory register
ddr2cfg5 Show or set the reset value of the memory register
ddr2delay Change read data input delay.
ddr2skew Change read skew.
detach Resume execution with GRMON detached from processor
disassemble Disassemble memory
dump Dump memory to a file
dwarf print or lookup dwarf information
edcl Print or set the EDCL ip
eeload Load a file into an EEPROM
ehci Controll the USB host ECHI core
ei Error injection
ep Set entry point
execsh Run commands in the execution shell
exit Exit GRMON
flash Write, erase or show information about the flash
float Display FPU registers