GRMON3-UM
June 2019, Version 3.1.0
173 www.cobham.com/gaisler
When the commands pci trace address, pci trace amask, pci trace sig, pci trace smask, pci trace tcount and
pci trace tdelay are used to read values, they return their values.
The pci trace log command returns a list of triples, where the triple contains the address, a list of signals and
buffer index.
Command pci trace state returns a tuple of the address and a list of signals.
EXAMPLE
Initialize host controller and configure the PCI bus
grmon3> pci init
grmon3> pci conf
Inspect a PCI bus that has already been setup
grmon3> pci scan
SEE ALSO
Section 6.17, “PCI”
To Next Page
Loading...