COBHAM GRMON3 - Page 220

GRMON3-UM
June 2019, Version 3.1.0
220 www.cobham.com/gaisler
111. wmdio - syntax
NAME
wmdio - Set PHY registers
SYNOPSIS
wmdio paddr raddr value ?greth#?
DESCRIPTION
wmdio paddr raddr value ?greth#?
Set value of PHY address paddr and register raddr. If more than one device exists in the system, the
greth# can be used to select device, default is greth0. The command tries to disable the EDCL duplex
detection if enabled.
SEE ALSO
Section 6.4, “Ethernet controller”