3.1.7 Before the commissioning
Before the commissioning of the machine, it must be checked that all parts have been installed according
to the documentation and instructions from COBOD International A/S.
Before the commissioning of the machine, all relevant personnel must be instructed in the documentation
of the machine – including instruction manual, maintenance instructions, diagrams etc.
3.1.8 Limits of machinery
3.1.8.1 Use limits
The BOD2 is intended for use on construction sites and will be
installed inside (typically in a tent).
• 3D print of objects within the dimensions of the machine.
• Automatic mode used to move the machine based on G-code.
• The machine can be operated manually.
• The machine is operated from a web interface or from a touch panel.
• The supply disconnector is installed outside of the operating area of the machine.
• Energy supply: see Power Sources.
3.1.8.2 Space limits
The foot print of the BOD2 444 is:
• Length = 10.1 m.
• Width = 12.6 m
• Height = 10.5 m.
3.1.8.3 Time limits
The service life of the machine is 20 years of a daily 8-hour operation. This is based on the presumption that
all service and maintenance instructions described in this instruction manual are observed carefully.
3.1.8.4 Other limits
The BOD2 is intended for use on construction sites and must be installed inside (typically in a tent).
Printing material is a premix of concrete and cement-based mortars.
Temperature limits: 5 °C to +50 °C.
To Next Page
Loading...