Instruction Manual - Original Version
5.4.2 Electrical installation
The connection of the machine must only be made by an authorized electrician. During the installation, the
law of the country must be followed.
For the proper connection and information of voltage and power consumption, see the electrical diagram.
Figure 9: Electrical connectors
• 1 x Large flathead screwdriver
Procedure
1. Locate all the cable connectors and sockets on the machine.
2. See the markings on connectors to identify correct socket.
3. Connect all connectors to the carriage sockets.
4. Tighten all connector hoods with a flathead Screwdriver as in Figure 9.
Connect power cable to socket located on bottom of E-box. Connect to external power source.
Circuit breaker is located on machine E-box. The circuit breaker also serves as service switch and must be in
a locked position during repair work.
To Next Page
Loading...