should be set to static, within the same
address space as printer.
4. Turn printer off, wait 10 seconds, and turn
it on again. Try to reconnect.
Extruder is clogged, printer goes into error
mode when trying to extrude material
Material is too hard, or has hardened inside the
pump unit. Immidiately clean the material hopper,
while shifting between extrude and retract, until
pump unit has loosened and material comes out. F
printer goes into error mode, restart on green
“start” buttom every time.
8 Service
8.1 Service intervals
The servicing of the machine must be carried out by trained personnel only. Various tasks may require
various skills and training. The instructions of this section are meant as a minimum requirement and must
be carried out according to the below plan.
The maintenance staff must have read and understood this instruction manual before the maintenance of
the machine is commenced. If specific tasks require the use of personal protective equipment, the
requirement must be complied with by all occupational groups.
For the documentation purpose of maintenance tasks, the keeping of a logbook or similar is recommended.
If the regular maintenance of the machine cannot be demonstrated, the manufacturer’s warranty may
lapse.
Special precautionary measures to be taken during a maintenance task will be described under each single
task. For general maintenance and cleaning tasks, the general guide lines are followed for the safe work at
the machine. This includes the use of personal protective equipment, and that machines and components
are put into a safe condition before the task is initiated and that the manufacturer instructions are
complied with.
A service visit should be performed twice yearly.
8.2 Customer service
To Next Page
Loading...