7.2.9 9 – Inspect hoses
Inspect material feeder hoses for wear and tear.
7.2.10 10 – Inspect mixing shaft
Inspect mixing shaft for damage or bending.
7.2.11 11 – Inspect cables
Inspect external cables for visible damage or wear.
7.2.12 12 – Inspect E-chains
Inspect E-chains for visible damage or wear.
7.2.13 13 – Grease tooth rack
7.3 Maintenance and cleaning made by the cleaning personnel
Cleaning tasks to be made by the cleaning personnel is described in this section. The instructions are meant
as a minimum requirement and are to be carried out according to the plan below.
The cleaning personnel must have read and understood this instruction manual before any maintenance
and cleaning of the machine is commenced.
If specific tasks require the use of personal protective equipment, this must be complied with.
For the documentation purpose of maintenance and cleaning tasks, the keeping of a logbook or similar is
recommended. If the regular maintenance and cleaning of the machine cannot be demonstrated, the
manufacturer warranty may lapse.
Special precautionary measures to be taken during a maintenance and cleaning task, is described under
each single task. For regular maintenance and cleaning tasks, the general instructions for the safe work at
the machine are to be followed. This includes the use of personal protective equipment, and that machines
and components are put into a safe condition before the task is initiated and that the manufacturer
instructions are complied with.
To Next Page
Loading...