Instruction Manual - Original Version
5 Handling
This section describes how the machine is to be operated in various situations. Where specific personal
qualifications are required, this will be described.
Installation and dismounting of the machine must be carried out by qualified and trained personnel. To
prevent accidents, all safety instructions must be observed.
5.1 Transport and storage
The machine is built of components from various suppliers. Some of these parts are of a size, shape and
weight that require special handling. Follow the instruction manual from the manufacturer or supplier on
how to apply lifting equipment and the appropriate lifting points.
Only instructed and certified personnel have the permission to move machine parts using a
fork lift truck or crane.
Only appropriate and certified equipment must be used for the lifting of machine parts.
5.2 Unpacking
When unpacking the machine, it is to be controlled if damage to the machine has occurred during
transport. Damage affecting the functionality or safety of the machine must be repaired before the
machine is put into operation.
5.3 Safe disposal of packing material
Packing material consists of:
- 120x120x1500mm wooden joists
- EU Pallets (120x80 cm)
Both are reusable items and should not be disposed of, unless damaged. If damaged or unusable, dispose
as wooden waste according to local law.
5.4 Installation and assembly of the machine
5.4.1 Mechanical assembly
To Next Page
Loading...