Cable trays should always face upwards or to the side to avoid damages while transporting/handling. Cable
connector ends must be stored inside trusses.
Figure 12: correct placement of axes
5.6 Repacking
Transport of the BOD2 printer must be done in 8 parts
• 1 X-beam (including X- and Y carriages)
• 2 Y-beams
• 4 Z-beams (Including Z carriages and E-box)
• Printhead (including cables)
Transport on truck must be stacked according to figure 1, and tightly secured using straps.
5.7 Placing of instructions
Personnel should refer to this manual. If in doubt, please contact COBOD International before handling or
transporting this machine.
To Next Page
Loading...