Charging the internal battery
Although Snooper can be charged using the vehicle charger in your vehicle, an
alternative method of charging via a USB socket of a PC, or USB Mains charger
(output of 5v 1000mA) - not supplied.
Connect the device to the PC or external power, the unit will switch On
automatically. To speed the charging process switch the unit off by holding the
power button for 7-10 seconds. The battery icon will appear on the screen to
indicate that the unit is on charge.
Note: The new battery’s full performance is only achieved after two or three
complete charges and discharges.
Powering Snooper using the built-in battery
Once Snooper is fully charged, it is ready for use. Press and hold the power switch on the top of the unit for 2 seconds to switch on
the device.
Note: the battery is designed to be a back up and Snooper recommends that the the navigation device is powered from the
vehicle charger.
On Press and hold for 2 seconds
Off Press and hold for 7 - 10 seconds
Plug the
charger cable into
the USB socket on the
side of the Snooper
To Next Page
Loading...
Need help?
General
