7.0 Quick Access Menu
A small on-screen Menu can be launched by touching the screen anywhere along the top 10mm of the display. See diagram below.
The quick access menu will drop down automatically. If no other buttons on the drop down box are pressed the drop down box
disappears after approximately three seconds.
From this Menu you can:
Zoom closer in, or zoom further out from the map.
Mute or alter the audio level.
By pressing the
icon you can manipulate the map.
Switch between the 2D, 3D and North views.
Switch between day and night settings.
Switch off the speed camera location facility.
7.1
Volume Setting
Selecting this option opens the Volume menu whereby you can increase or decrease
the audio level of the unit. Press the ‘Volume Control’ icon. To adjust the volume, use
your finger to press either the
button to increase the volume or the
button to
decrease the volume (Does not apply for the S2500 Model).
Please note that this new setting is only temporary and if Snooper is
switched off and then back on the audio level returns to either the factory
default or your personalised setting.
If you press the speaker icon
you can turn off the audio on the unit
completely. A symbol is displayed in the top left hand corner of the display
to indicate that the sound has been switched off. If Bluetooth is activated the
symbol is not visible.
To switch the sound back on press the screen near the top of the display and
select the ‘Volume Control’ icon. Press either the speaker icon or the volume
controls to restore audio on the unit.
7.2
Scroll Map
By pressing this icon you can manipulate the map by touching and moving your finger on the screen.
7.3
or
Day or Night Settings
Bright colours are normally used for the mapping display so that you can see the map more clearly, even in bright sunlight. When it is
dark outside however, you may want to switch to the Night Mode
as the daytime setting will be too bright.
The navigation view will then be displayed using dark and subdued colours that will not interfere with your night vision.
Use Day
to revert to the original colour scheme.
Please note: If you switch the unit off and then back on the display reverts to your previous personalised setting.
To Next Page
Loading...
Need help?
General
