5.12 System Security Code (on Truckmate, Bus & Coach or Ventura this icon will NOT be visible if the unit is in CAR mode).
Snooper incorporates pin code security protection so that only users with access
to the pin code can use and operate the device. To activate the security code
press the centre of the display to access the menu, press ‘Configure’ , press the
black arrow twice and then press the ‘System Security Code’ icon. Select ‘Ye s ’ to
switch the function on. Press the ‘Enter Code*’ button and enter the 4 digit code
that you would like to use to protect your Snooper and press ‘OK’.
*If the button displays ‘Change Code’ then a security code has already been set.
Press ‘Change Code’ to edit the system security code.
Once this setting has been activated you will need to enter this code each time you power on your Snooper or you will not be able to
operate the device.
NB. It is important that you do not lose or forget this code. If you forget this code you will need to return your Snooper so that
the unit can be reset.
5.13 Configuration Security Code (on Truckmate, Bus & Coach or Ventura this icon will NOT be visible if the unit is in CAR mode).
It is also possible to protect the configuration settings using a security pin code.
To activate the security configuration code press the centre of the display to
access the menu, press ‘Configure’, press the black arrow twice and then press
the ‘Configuration Security Code’ icon.
The methodology of setting this code is the same as described in section 5.12
‘System Security Code’.
Once this code is set the user will not be able to change any of the settings,
within the ‘Configure’ menu, without entering the code. This includes using an
alternative Truck or Caravan (when programmed) when plotting a route.
NB. It is important that you do not lose or forget this code. If you forget this code you will need to return your Snooper so that
the unit can be reset.
Enter code Incorrect code entered Correct code entered
To Next Page
Loading...
Need help?
General
