5.14 Route Timer
This function allows you to set an alert for when you need to take a break. Set the maximum driving time allowed and set the
advanced warning time you require before your next break is due. The Route timer clock will then keep you advised of the driving
time you have left and will automatically alert you when it’s time to take a break.
To access this function:
Press the centre of the screen to enter the ‘Navigate to’ menu.
Press the ‘Configure’ button.
Press the arrow
once.
Press the ‘Route Timer’ icon.
The following screen will be displayed. In this screen you can:
Activate the route timer function so that it is shown in the map display. Note: If ‘ Ye s’ is not selected then you cannot amend the
‘Set time limit’ and ‘Alert time’ options
Set the duration of the time limit in hours and minutes - use the arrows to
increase or decrease the time. The default setting is four hours.
Before the time limit is up you can configure the unit to provide you with an
alert to remind you that you are nearing your break period. The default period
is 20 minutes.
Once you have set your
desired preferences press
‘OK’ to confirm the settings.
If you wish to keep the
setting unchanged, you can
exit the menu by pressing
the return arrow
located in the bottom right
hand corner of the display.
Route timer
Pause Stop Reset
Press route timer to
show options
To Next Page
Loading...
Need help?
General
