10.4.5 Bluetooth Interface Installation
The Bluetooth interface should be mounted within 16 feet (5
meters) of the unit. It should be mounted securely with the screws
provided. We would recommend that the unit is accessible for
programming purposes.
The Bluetooth interface should have 12V/24v DC power when the
vehicle is moving. The red cable is positive and the black wire is
negative.
10.4.6 Repeater/Signal Booster Installation
Recreational Vehicles, Tow Vehicles, Trailers and Tractor Trailer *
* (If you have a Tractor Trailer that does drop and pulls of multiple trailers you need to use the STP6 section because it requires a link
function)
The Repeater/Booster is designed to amplify the signal from your TPMS system sensors. In situations where length or interference
prevents your monitor from receiving a signal, the Repeater/Booster increases the sensors transmitting distance.
This should not be needed to monitor distances of 53 feet or less. However, some vehicles experience difficulties due to the amount
of electronic components in the engine compartment as well as where sensors are shielded by bodywork etc. causing sensor signal
strength to be reduced and where extremely cold temperatures may reduce sensor battery power.
The optional signal Repeater/Booster can be ordered separately and is available at www.snooper.co.uk
The booster should be installed as low as possible on the rear of the towing vehicle or at the front of the trailed vehicle.
The hard wired booster should have 12V/24v DCC power when the vehicle is moving.
The red cable is positive and the black wire is negative.
To Next Page
Loading...
Need help?
General
