Connecting Power to your Frame
Your Photo Frame should be connected to
an AC 100-240V wall outlet.
Using the supplied power adapter,
plug one end of the adapter into
your photo frame’s Power In Jack
and plug the other end into an AC
100-240V wall outlet.
Do not connect the power plug to a power outlet other than that
which is indicated here or on the label as this may result in the risk
of re or electric shock.
Do not handle the power plug with wet hands. Doing so may cause
electric shock.
Use only the AC adapter supplied with the photo frame. Failure to
do so may cause a re or damage the player.
Turning Your Photo Frame On/Off
To turn your photo frame on, set the Power Switch to the “On” position.
To turn your photo frame off, set the Power Switch to the “Off” position.
If no memory cards have been loaded, the photo frame will auto-
matically display a demo slideshow after 10 seconds. To stop the
demo slideshow, press any button or load a card.
•
•
•
Getting Started
To Next Page
Loading...
Need help?
General
