Coca-Cola Freestyle 7000 - Cleaning Procedure; Prepare Sanitizer; Sanitize the Pump Kit Parts

Chapter 7: Water Circuit Cleaning
Classified – Confidential Page 40 of 46
Cleaning Procedure
I. Prepare Sanitizer
Step
Action
4.
In a clean 5 gallon Bucket, prepare 5 gallons of Kay-5 Sanitizer (two 1oz packet of Kay-
5). Use hot water.
Note: Do not exceed 100 ppm Sanitizer strength as this causes damage to the
equipment.
5.
Mix the solution well.
6.
Bring the Bucket to the dispenser.
II. Sanitize the Pump Kit Parts
Step
Action
1.
Rinse the Tubing Kit Fittings from the Water CIP Tubing Kit in warm water to remove
any debris or soiling.
2.
Place the rinsed Tubing Kit Fittings into the Bucket of Sanitizer.