3.6 Quick Pop-up Menu
Right-clicking the mouse whilst on the viewing screen will show the pop-up menu for quick access
to basic functions.
1. Single – Switch to single camera view mode. Select the camera you want to view
2. Multi – Switch to split screen mode
Tip: Alternatively, use the mouse and double click with LMB on the image to switch between
the two modes
3. PTZ – Access PTZ (Pan Tilt Zoom) controls via shortcut. Must have PTZ camera (not included)
installed and connected
4. Start/Stop Scan – This will show each camera in single view and at selected intervals switch
between each camera automatically
5. Colour – Adjust the colour settings of the selected camera
6. E-Zoom – Select an area on the camera screen to get a close up view. You can also select the
size in which you want to zoom to by selecting the numbers in the bottom right corner of the
screen. Right-click to return to full screen mode
7. Audio – Audio settings. Must have Audio input and output devices (not included) installed
and connected
8. Snap – Take a photo from the selected camera (A camera icon will show up indicating a photo
has been taken). To access photos, see section 6.2 Main Menu - Search on page 34
9. Start/Stop Record – Start and Stop 24/7 recording all cameras (default settings). In the
bottom left corner of each camera view, you will notice a green box, this means the cameras
are recording. If there is no green box they are not recording.
NOTE: If footage is captured by motion detection (see section 6.1.4 Schedule on page 28),
a yellow square and ‘MD’ will appear instead
10. Playback – Enter playback mode to view recently recorded footage
11. Main Menu – Access the main menu to congure DVR settings
Once you have set your username and password, your Home Security System is fully setup.
To setup and view your cameras on mobile see sectionsection 4.1 Use Apple or Android mobile
to access footage on page 17 or for PC see section 5.1 Cocoon HD Software for PC Use on
page 21
DVR Operation
To Next Page
