Cocoon HE180040 - Network

30
After Sales Support
1300 663 907
Model Number HE180040
customercare@winplus.com.au
After Sales Support
1300 663 907
Model Number HE180040
customercare@winplus.com.au
6.1.6 Network
Network tab
Congure your network settings here:
• HTTP Port: Default value is 80
• Server Port: Default value is 5000
• Mobile Port: Default value is 5001
• Obtain an IP Address Automatically: To obtain the IP function automatically (We recommend
leaving this box ticked)
• IP Address: To set the IP address of the device
• Subnet Mask: To set the subnet mask of the device
• Gateway: To set the default gateway of the DVR
• Preferred DNS Server: This address is provided by your network operator and must be lled in
when using mobile monitoring
• Alternate DNS Server: This address is provided by your network operator
• PPPOE: When enabled, the DVR will automatically establish a network connection in the
form of PPPOE, then the IP address can be seen through Main Menu Information Network
• Username: For PPPOE mode, enter the ISP (Internet Service Provider)
• Password: For PPPOE mode, set password
• Test: Check whether the entered IP address and PPPOE information are valid or not
Sub-Stream tab
Denes which channels are displayed over the web along with frame rates and bitrates.
• Resolution: Supports CIF only
• FPS: Set framerate to send over the network, frame rates depend on the host and local
• bandwidth
• Encode: Supports VBR and CBR
• Quality: Select between Higher, Medium, Low, Lower, Lowest
• Max Bitrate: Set the maximum bitrate that each channel will transmit
Advanced Settings