6.3 Main Menu - Backup
Backup allows you to transfer recordings to a USB ash drive up to 32GB formatted to FAT32.
1. Insert a USB ash drive into the rear of the DVR unit
2. On the right-hand side, enter the start and end times to search, then press ‘Search’
3. A list of footage les that have been recorded by the DVR will be shown. Select your desired
les for export by ticking the le
4. Once selected, press the ‘Backup’ button, then press ‘Start’
5. Wait until the backup is complete before exiting and removing the USB ash drive
NOTE: If the USB has insucient space for transfer, select ‘Disk Cleanup’. Files can now be highlight and
deleted using the ‘Delete’ button
6.4 Main Menu - Information
6.4.1 System
Displays system information of the DVR. If you are wanting to setup the DVR to be viewed on a
smartphone, two QR codes allow easy set up for mobile monitoring. For more information,
refer to section Mobile Phone Setup on page 17
6.4.2 Event
Search for motion and video loss logs that have occurred on the DVR
1. On the right-hand side, select the date to search, then press ‘Search’
2. A list of log les will be shown
6.4.3 Log
Search for operational logs that have occurred on the DVR.
1. On the right-hand side, select the date to search, then press ‘Search’
2. A list of log les will be shown. Double-click on an entry for more information
NOTE: A log le can be exported to a USB ash drive using the ‘Export’ button
6.4.4 Network
Displays a list of your DVR’s current network settings. This is useful to conrm which IP address
your DVR has been assigned.
Advanced Settings
To Next Page
Loading...
