EasyManua.ls Logo

Code Alarm Professional ca5054 - Page 35

Code Alarm Professional ca5054
45 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Using Your Remote Control
Using the Keyless Entry
The
&J
button
is
used to lock
the vehicle's doors, the
~
button
is
used to unlock the
vehicle's doors.
To
lock or unlock the doors simply press and release the desired
function button one time. For your convenience, the parking lights
will flash
once when
the doors are unlocked and twice when the door are locked.
NOTE: The system
is
defaulted with Silent Choice enabled, which requires a second
press
of
the
@
or button to activate
an
audible locking/unlocking response from
the vehicle. If
your system
is
set up for 2 step unlock, a third press of unlock
will
activate the audible response.
Two
Stage Door Unlock (Optional)
If
this feature
is
enabled
on
your system, pressing the
,?
button one time
will
unlock
only the driver's door. Press again within three seconds to unlock the remaining
doors.
Activating the Trunk Release Feature (Optional)
The button is used to open the trunk of the vehicle.
To
open the
vehicle's trunk
press and
hold
the button for 3 seconds.
Using the Progressive Car Finder Feature
Press the
c::J
)))
button to locate your vehicle. The system
will flash
the parking lights
and sound 5 times at
low
volume, increasing
in
volume each time the button
is
pressed.
Using the Personal Protection Alarm (Panic)
Press and
hold the
c::J
)))
button for 3 seconds to activate the personal protection alarm.
During panic mode, the normal function of the transmitter buttons
will
be
suspended.
The transmitter's
@
and buttons can be used to
lock
and unlock the door (if the
option
is
installed).
To
stop the alarm, press and hold the
c::J
)))
button
on
the transmitter
again for 3 seconds. The system
will automatically
stop after
30
seconds.
Programmed Transmitter Notification
As a security precaution each time the vehicle's ignition is turn
on
the status LED
light with
flash
the number of transmitters programmed into the system. This
helps
to identify unauthorized transmitters from accessing your
vehicle. If you believe
an
unauthorized transmitter has been programmed to your system, contact your
installing
dealer for assistance.
2014 Voxx Electronics
Corporation.
All
rights reserved.
3

Related product manuals