Code PHANTOM 1024 - Using Group; Examples

Phantom_1024_V2.023_en.PDF http://www.codelight.com
14
3.9. Using Group
You can collect the same type fixtures into a Group, so that you can easily control them all together.
Example: Set Unit button 1-10 as Group 1
 In the “Live Show Mode”, select Unit button 1-10;
 Press S5 [Group];
 Enter No. 1 in the Numeric keypad or roll the control wheel A to No. 1;
 Press S4 [Save Group].
Once you create the group, you can rapid select fixtures or dimmer channels.
Example: Choose Group 1.
 In the “Live Show Mode”, press S5 [Group];
 Enter No. 1 in the Numeric keypad or roll the control wheel A to No. 1;
 Press S1 [Load Group].
An easier way to select a group:
 In the “Live Show Mode”, press button No.1;
 Press S3 [Recall a Group].
3.10. Examples
How to set Martin Mac2000 Profile on the Unit button 10 to go yellow and change its position?
 In the “Live Show Mode”, Press Unit 10;
 Press Locate;
 Press S1 [Locate Fixture];
 Press A4 button in the Preset section, and set it as yellow;
 Press Tilt/Pan button in the Attribute section, and change the position of fixtures by using control wheel A
and B.