Phantom_1024_V2.023_en.PDF http://www.codelight.com
25
6.10. Runtime Parameter of Program
You can set up all kinds of runtime parameter of playback:
In the “Live Show Mode”, press S3 [Edit Time];
Choose the needed Playback button and edit the 6 runtimes according to your need.
Each Playback contains 6 runtime parameters:
1．Wait in --- the time between the begin of a step and the begin of a Fade in.
2．Fade in --- the time a step spend on the HTP Fade in.
3．Wait out --- the time between finishing the Fade in of a step and beginning its Fade out.
4．Fade out --- the time spend on HTP Fade out when step stops.
5．LTP Wait --- the time between the begin of a step and the begin of an LTP Fade in.
6．LTP Fade in --- The time of all the LTP Fade in of the Playback.
You can also rapid edit the total time of Playback in the performance:
Fade in a Playback;
You can press Shift in the Numeric keypad and hold still, then press the needed Playback button to set it
as the current state. Thus, you can control the speed of Chase by control wheels (The LCD screen will
display “PB Speed”).
6.11. Change the Runtime Parameter Load Mode of the First Chase Step
In “Live Mode”, press S1 [Playback Parameters], you can change the runtime parameter load mode of the first
step of the running Playback. Use S1 to select the 3 mode:
Wait & Fade for All steps;
Skip First Wait time;
Skip First Wait & Fade time.
To Next Page
Loading...