Code PHANTOM 1024 - User Setup; Set up Language; Set up MIDI

Phantom_1024_V2.023_en.PDF http://www.codelight.com
37
9.2.2.3. Clear all the Preset and Playback
You can clear all the Preset and Playback.
 Press S4 [Clear Preset and Playback];
 Press S1 [Confirm] to eliminate.
9.2.2.4. Clear all Data
Note: All the internal data, including Patch, Preset and Playback of the Units will be cleared, except
the uploaded library!
 Press S5 [Clear All Data];
 Press S1 [Confirm] to clear.
9.3. User Setup
 Press Setup;
 Press S5 [User Setup];
9.3.1. Set Up Language
You can set up the language displayed in the console, which is in English or Chinese. You can press S1
[Set Language to Chinese] for Chinese and press it again for English.
9.3.2. Set Up MIDI
You can set up the parameters of MIDI.
Phantom 1024 can be used as a MIDI slave, thus MIDI Master can control its Playback program. It can
also be used as a MIDI master, when another Phantom 1024 used as a MIDI slave. They are connected by
MIDI cables and work in Master-Slave mode. You should make sure the two devices share the same MIDI
channel before you use MIDI to control the console.
9.3.2.1. MIDI Device
 Press S4 [MIDI Setup];
 Press S1 to switch the 3 modes.
MIDI device = Disable --- MIDI function closed;
MIDI device = Master --- Phantom 1024 is set to be the main device;
MIDI device = Slave --- Phantom 1024 is controlled by MIDI Master.