Code PHANTOM 1024 - Set up the System Parameters; Upgrade the Software; Clear Internal Data

To Next Page

To Previous Page

Phantom_1024_V2.023_en.PDF http://www.codelight.com

9.2. Set up the System Parameters

The upgrade of the software of the console and the elimination of internal data will be introduced in this part.

Before update the version, please back up the data.

9.2.1. Upgrade the Software

 Download the latest software from http://www.codelight.com and save it in USB flash driver;

 Insert the USB flash driver;

 Press Setup;

 Press S4 [System Parameters];

 Press S1 [Upgrade Firmware];

 Use 、 to select the edition of the software to update;

 Press S1 [Confirm], please read the notice on LCD screen;

 Press Enter to upgrade;

 After finish updated and restarted the console, please execute the operation of “clear all data”.

Note: Make sure the constant power supply and never cut off the electricity or turn off the console during

the update!

9.2.2. Clear Internal Data

You can clear the internal data of the console.

 Press Setup;

 Press S4 [System Parameters];

 Press S4 [Internal data Clear];

There are 4 functions you can choose to operate. They are as follows:

9.2.2.1. Clear All the Preset Data

You can clear all the Preset data.

 Press S1 [Clear all Preset];

 Press S1 [Confirm] to clear.

9.2.2.2. Clear All the Playback Data

You can clear all the Playbacks.

 Press S2 [Clear all Playback];

 Press S1 [Confirm] to delete.