Victory 3_en.pdf http://en.codelight.com.cn
27
7.4.2.2. Fixture Order
The [Fixture Order] in Cue-lists should run with ‘Fixture Overlap’. You cannot find the effects if you did not set
up fixture overlap in advance. The way of setting ‘Fixture Order’ please refers to chapter 4.4.2.1.
However, you may close some of the fixtures if you don’t want them to run with fixture overlap. The closed fixture(s)
will start to run as soon as the first fixture(s) begin, and finish at the same time as the last fixture(s) ended.
7.4.2.3. Fixture Overlap
The [Overlap] allows you to run a series of fixtures with chasing effect in one step. The range of overlap is from
0%~100%.
When overlap=100%, all fixtures will change together. If overlap=50%, the second fixture will not start until the first
fixture is halfway (50%) through fading. The running sequence of fixtures follows the setting of the fixture order.
The running time will be divided equally for each fixture. That means if there are 5 fixtures run in 10s for the step.
After setting the fixture overlap, each fixture uses 2s to finish its effect.
7.4.2.4. Link Mode of Cue-lists
You can set the link mode to each cue in the playback. To run this function, you should set the [Link Mode] as
‘inside’ from ‘Playback Edit Menu’.
When the Link is ‘OFF’, the cue will stop at the last scene unless getting the instruction to run the next cue.
When the Link is ‘ON’, the cue will go to the next cue after it is finished.
7.4.2.5. Edit Effect
You are allowed to adjust the effect which had been saved as playback.
1> Press Edit Playback in ‘LIVE SHOW’;
2> Select the playback to be edited;
3> Select the cue to be edited then select [Effect] to enter the effects menu;
To Next Page
Loading...
Need help?
Display
Power
Weight and Dimensions
