CODEL SmartCem V-CEM5100 - 3 Specification

Technical Manual Page 6 CODEL
OPS.109
Issue : B
Rev. : 1
Date : 23/10/13
Doc. i/d : 0109/6
Ref. : 090028
3.
Specification
Measurement Range : selectable to 50m/s
Response : selectable 10 seconds to 30 days
Accuracy :  ±2% of measurement
Serial Port : data bus I/P & O/P.
Construction : fully sealed (IP65) epoxy-coated aluminium enclosures
Ambient Temperature Limits : -20
o
C to +70
o
C - transducers
-20
o
C to +50
o
C - PSU, SPU & DDU
Power Requirements PSU : 90-264V AC max., 50/60Hz
V-CEM : 48V DC (from PSU)
Air Purge Consumption : 1 l/s @ 1 bar (compressed air), dry (to -20C) & clean (better
than 10m)
Analogue Outputs (DDU) : 2 x 0/4-20mA current outputs, isolated, 500 load max., fully
configurable from keypad
Logic Outputs (DDU) : 2 x volt-free SPCO contacts, 50V, 1A max. configurable as alarm
contacts
: 1 x volt-free SPCO contact, 50V, 1A max. for data valid
General : DDU display - 32-character alpha-numeric back-lit LCD
DDU keypad - 4-key soft-touch entry
Construction : PSU/SPU/DDU - epoxy-coated aluminium