1
Introduction:
The In-Sight 2000 is a vision sensor, capable of providing a pass/fail output from the inspection of a
part. It is easier to use than a full vision system but has capabilities beyond a basic photosensor or
proximity sensor, or even an array of sensors. It uses the same software used for programming a
Cognex In-Sight vision system, so you don’t need to learn a separate software to configure it.
You will learn about the In-Sight 2000, its components, interchangeable parts, configuring an IP
address, connecting to the IS2000 and programming an inspection. This document will also serve
as a reference for the primary functionality of EasyBuilder and the stepwise process for building an
inspection.
In the first lab you will be guided in each step, which will be explained in detail. After that you can
use your own parts (if you brought some) to create an inspection for your application or use our
parts and create an inspection according to set criteria.
To Next Page
Loading...
Need help?
General
