Colorlight X2 - 5. Parameter Configuration; 5.1 Detect Sender and Receiving Card

www.colorlightinside.com
4
② After selecting a language, an installation wizard like below will appear, click [Next];
Then choose installation location, click [Browse] to change default target location, then
click [Next] after completing;
Choose components according to your own computer status, click [Install] to complete;
After the installation is complete you are ready to use LEDVISION.
5. Parameter Configuration
Please make sure the correctness of the hardware connection before setting, use
LEDVISION to detect sender and all receiving cards.
5.1 Detect Sender and Receiving Card
1. Run LEDVISION, click [Control] – [Screen Control] to enter the Screen Control
window.