15
MACHINE PREPARATION
3. push the connection lever (2) to the left
4. Raise the squeegee and insert the small right-hand column (3) in the connection hole
5. Release the connection lever (2) so it is blocked in the flat housing of the small column
6. Insert the suction tube (4) in the appropriate squeegee sleeve (5), ensuring that the tube lies to the
right of the lifting cable
ATTENTION: these operations must be carried out using protective gloves to
avoid any possible contact with the edges or tips of metal objects
15. ADJUSTING THE SQUEEGEE INCLINATION
During movement, the rear rubber should be slightly tilted backwards in a uniform manner at an angle
of about 45 degrees to the floor along its entire length of about 5mm. If it is necessary to increase the
bend of the rubber in the central part, you must tilt the squeegee backwards, rotating the adjuster (1)
anticlockwise. To increase the bend of the rubber at the sides of the squeegee, rotate the set screw
clockwise.
16. ADJUSTING THE SQUEEGEE HEIGHT
The height of the squeegee must be adjusted on the basis of the state of wear and tear of the rubber.
To do this, turn the knob (2) anticlockwise to raise the squeegee, and clockwise to lower it.
Remarks: the right and left wheels must be adjusted to the same level, so the squeegee can work
parallel to the floor.
17. RECOVERY TANK
Check the cap of the drainage tube (on the rear of the machine) is correctly closed.
ATTENTION: To avoid foam production, put a minimum quantity of antifoam
liquid in the recovery tank before starting to clean
2
1
1
5
4
3
2
To Next Page
Loading...
