22
AT THE END OF THE WORK
1. AT THE END OF THE WORK
At the end of the work, and before carrying out any type of maintenance:
1. raise the base by means of the pedal (1)
3. Raise the squeegee by means of lever (2) When the squeegee is up, the suction motor switches off
automatically
4. Bring the machine to the place provided for draining the water
5. Turn the key switch (3) counter-clockwise to "0" to turn off the machine, for the electric versions
unplug the machine from the mains.
6. pull the brake lever and block it with the pin (4)
7. Remove the drainage hose (5) from its compartment, unscrew the drainage cap (6) and empty the
recovery tank
8. disassemble the brushes and clean them with a jet of water (to disassemble the brushes, see
“DISASSEMBLING THE BRUSHES” below)
9. The squeegee and the base must be off the ground when the machine is not operating to prevent
deforming the squeegee and brush.
10. At the end of the work, park the machine indoors, turn the ignition key counter-clockwise (this
disconnects power to the main switch of the machine) and remove the control key; for the electric
versions unplug the machine from the mains. Apply the parking brake and block the handle with the pin
(1), inserting it in the lever holes. After inserting the pin (1), ensure the flat surface of the pin is resting on
the surface of the handlebars.
ATTENTION: do not leave the machine unattended without first removing the
start-up switch key and applying the parking brake. In addition, do not park the
machine in open places or on sloping floors
1
2
3
4
5
6
1
To Next Page
Loading...
