ComAp InteliGen - Page 48

Alarm list
1. Details of the alarm from
ECU indicated by the
cursor are displayed at the
bottom line (SPN, FMI, OC
numbers)
2. Asterisk indicates not
accepted alarms (Fault
reset has not been
performed)
3. Alarms displayed inverted
are active
4. Number of active / not
accepted / all alarms
Measurement CU
SPtM Screens
Description
1. Remote communication
indication and access lock
indication (symbol is
visible when Access lock
BI is active).
2. Actual gen-set power.
3. Measure screen address.
For jump to this screen
set this number from the
numeric keypad.
4. Actual engine RPM.
5. Actual power factor.
1. Power control mode
(Island / BaseLd /
BldEmLm / PwrI/E /
TbyPwr)
2. PF control mode (Island /
BasePF / PF I/E)
3. Required power value
4. Required PF value
5. Actual Mains active power
and PF values
6. Actual load active power
and PF values
7. Actual gen-set active
power and PF values
1
2
3
4
5
1
2
3
4
6
5
7
1
2
4
3
InteliVision 5, InteliVision 8 – Operator guide, ©ComAp – January 2014
IGS-NT Operator Guide 01-2014.pdf
48