ComAp InteliGen - List of Abbreviations

List of abbreviations
AI
Analog Input
AMF
Auto Mains Failure (controller starts automatically on mains failure)
AO
Analog Output
ATS
Automatic Transfer Switch (switches the load to actually supplied bus (by
mains or generators))
AVR
Automatic Voltage Regulator
BI
Binary Input
BO
Binary Output
BOC
Breaker Open & Cool-down - protection type (see application manual for
details)
BTB
Bus-Tie Breaker
CAN1
CAN bus for extension modules connection (e.g. IGS-PTM, IS-BIN8/16, IS-
AIN8, I-AOUT8, I-CB, IGL-RA15)
CAN2
CAN bus for intercontroller communication (in multiple applications) and
monitoring (connection of I-LB, IG-IB)
Combi
Application where SPTM, SPI or MINT can be used. Application is defined
by Binarary inputs combination.
COX
Application for Complex Systems where actions are taken by a PLC and
the controller only follows the orders => needs an external driver (cox)
ESF
Engine Specific File
FMI
Failure Mode Identifier
GC
Graphical Characters - option for additional support of one "graphical"
language
GCB
Generator Circuit Breaker
CHP
Combined Heat & Power - cogeneration application, usually with gas
engine
I-AOUT8 Extension module with 8 AO
I-CB
Communication Bridge - interfaces IS, IG/IS-NT, ID controllers and non-
standard engine ECU
IG-AVRi
IG Automatic Voltage Regulator interface
IG-EE
InteliGen for Electronic Engines (HW optimized for connection to an engine
equipped with ECU)
IG-EEC
InteliGen EE controller with extended communication possibilities +
switchable sensing ranges of AC voltages and currents
IG-IB
IG Internet Bridge - for internet/ethernet communication
IGL-RA15 Indication panel with LEDs signalizing state of 15 BO
IG-NT
InteliGen New Technology gen-set controller
InteliVision 5, InteliVision 8 – Operator guide, ©ComAp – January 2014
IGS-NT Operator Guide 01-2014.pdf
57