InteliLite Global Guide
110
Image 5.24 Daily mode - InteliConfig
In timer mode select Repeat. In repetition type select Daily. In timer settings adjust date and time of first
occurrence of timer. Also adjust the duration of each occurrence of timer. Than select the x-th day of repetition
(Timer 1 Refresh Period (page 307)) and behavior of timer on weekends (Timer 1 Weekends (page 308)).
Example: On image example first start of timer will be 1/1/2016 at 12:00. Duration will be 1 hour. Timer will
be again activated every 3rd day at 12:00 for 1 hour including weekends.
Set-up via controller interface
In controller go to the Scheduler setpoint group. Select the function of timer via Timer 1 Function (page 303)
setpoint. Than go to Timer 1 Setup and press enter button. In Timer 1 Repetition (page 304) setpoint select
Repeated mode. Than adjust Timer 1 First Occur. Date (page 305), Timer 1 First Occur. Time (page 305)
and Timer 1 Duration (page 305). In setpoint Timer 1 Repeated (page 306) select Daily and adjust Timer 1
Refresh Period (page 307) (x-th day of repetition) and Timer 1 Weekends (page 308) (behavior of timer on
weekends).
Note: Use left and right buttons to move between timer setpoints.
Weekly mode
Set-up via InteliConfig
To set-up timer via InteliConfig go to the setpoint ribbon, setpoint group scheduler and setpoint Timer 1 Setup.
Note: First of all function of timer has to be adjusted via setpoint Timer 1 Function (page 303).
To Next Page
Loading...
Need help?
General
