InteliLite Global Guide
322
Group: Geo-Fencing
Setpoint group Geo-Fencing Related FW 1.9.0
Range [units] -90,0000..90,0000 [°]
Default value 0,0000 ° Alternative config NO
Step 0,0001 °
Comm object 14606 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint adjust latitude of "home" position. Home is position where gen-set should runs. Positions on
north hemisphere have positive value, position on south hemisphere have negative value.
Note: This value with Home Longitude (page 322) are used for counting Fence Radius 1 (page 323)
and Fence Radius 2 (page 323).
Note: This value can be also obtained automatically via logical binary input GEO HOME POSITION (PAGE
530). In case of activation of this binary input for at least 2 seconds, setpoint will be adjusted
automatically from actual coordinates from GPS signal.
Home Latitude
6 back to List of setpoints
Setpoint group Geo-Fencing Related FW 1.9.0
Range [units] -180,0000..180,0000 [°]
Default value 0,0000 ° Alternative config NO
Step 0,0001 °
Comm object 14607 Related applications AMF, MRS
Config level Standard
Setpoint visibility Only if relevant module is installed
Description
This setpoint adjust longitude of "home" position. Home is position where gen-set should runs. Positions on
east hemisphere have positive value, position on west hemisphere have negative value.
Note: This value with Home Latitude (page 322) are used for counting Fence Radius 1 (page 323)
and Fence Radius 2 (page 323).
Note: This value can be also obtained automatically via logical binary input GEO HOME POSITION (PAGE
530). In case of activation of this binary input for at least 2 seconds, setpoint will be adjusted
automatically from actual coordinates from GPS signal.
Home Longitude
6 back to List of setpoints