IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
Another way of changing the SPtM application to either SPI or MINT one is by switching on BI: SPI Enable /
BI: MultipleEnable before switching on the power supply of the controller to activate SPI / MINT application.
In this case is not necessary to use BI: Emerg. manual to change the application.
NOTE:
In the case of an accidental contemporary activation of both BI: SPI Enable and BI: MultipleEnable the MINT
application remains active.
To Next Page
Loading...
Need help?
General
