IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
length limited up to 900 meters.
Change of this setpoint is applied after the controller is switched off and on
again.
NOTE:
Use low speed for long distance connection only. Set all connected controllers to
the same speed.
Setpoint: CAN2emptDetect
Enables the detection of missing other controllers on the CAN2 bus. If the setpoint
is in ENABLED position and there aren't any other controllers detected on the
CAN2 bus (the complete bus, not only within the logical group) the alarm
CAN2Empty is issued.
Setpoint: LB/UART Log
The setpoint enables/disables logging of remote communication activity. If logging
is enabled connection and disconnection of each remote terminal as well as
entering access code are recorded into the history.
NOTE:
The terminal is disconnected automatically after 5 min of inactivity and next
communication request from the same terminal is considered as a new
connection. When logging is enabled in certain conditions the history may be filled
up with large number of records related to the communication and important
records may be overwritten quite fast.
Setpoint: CANAddrSwitch1
To Next Page
Loading...
Need help?
General
