ComAp IS-NTC-BB

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
220
Setpoint: AcallCH4-Addr
Group
Act. calls/SMS
Range [units]
[-]
Related FW
3.0
Description
The setpoint is used to specify the recipient address for the active calls - channel
4. The content of the address must correspond to the selected alert type (e.g. it
must contain e-mail address if the alert type is e-mail). See the chapter Alarm
messaging for more details.
Setpoint: AcallCH5-Type
Group
Act. calls/SMS
Range [units]
[-]
Related FW
3.0
Description
The setpoint is used to specify the alert type of the active calls - channel 5. See
the chapter Alarm messaging for more details.
Setpoint: AcallCH5-Addr
Group
Act. calls/SMS
Range [units]
[-]
Related FW
3.0
Description
The setpoint is used to specify the recipient address for the active calls - channel
5. The content of the address must correspond to the selected alert type (e.g. it
must contain e-mail address if the alert type is e-mail). See the chapter Alarm
messaging for more details.
Setpoint: NumberRings AA
Group
Act. calls/SMS
Range [units]
1 .. 30 [-]
Related FW
3.0
Description
This setpoint is used to adjust the number of rings after which the modem, which
is attached to he controller, answers the incoming call.
Number of rings prior to answering the modem connection from PC to controller.
NOTE:
Any change of this setpoint is applied first after next switching the controller or
modem off and on or after disconnecting the modem from the controller and
connecting it back.
Setpoint: ActCallAttempt
Group
Act. calls/SMS
Range [units]
1 .. 250 [-]