ComAp IS-NTC-BB

IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
246
NOTE:
All terminals display binary values in "human-readable" form - from left to right.
That means the bit 0 is displayed in the most left position. This is different from
common use in computer science, where binary values are displayed from right to
left.
NOTE:
Click on button with "..." to get a clear list of BI names with their corresponding
values.
Value: LogBout 6
Group
Log bout
Units
-
Related FW
3.0
Description
This is a bit array containing status of logical binary outputs 81-96 of the
controller. Bit0 represents LBO81, bit1 represents LBO82 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to right.
That means the bit 0 is displayed in the most left position. This is different from
common use in computer science, where binary values are displayed from right to
left.
NOTE:
Click on button with "..." to get a clear list of BI names with their corresponding
values.
Value: LogBout 7
Group
Log bout
Units
-
Related FW
3.0
Description
This is a bit array containing status of logical binary outputs 97-112 of the
controller. Bit0 represents LBO97, bit1 represents LBO98 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to right.
That means the bit 0 is displayed in the most left position. This is different from
common use in computer science, where binary values are displayed from right to
left.
Value: LogBout 8
Group
Log bout
Units
-
Related FW
3.0
Description
This is a bit array containing status of logical binary outputs 113-128 of the
controller. Bit0 represents LBO113, bit1 represents LBO114 etc..
NOTE:
All terminals display binary values in "human-readable" form - from left to right.
That means the bit 0 is displayed in the most left position. This is different from
common use in computer science, where binary values are displayed from right to