IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
Value: kVArhours
Reactive energy counter.
NOTE:
The counter can be readjusted/reset from InteliMonitor menu Monitor -> Set
statistics.
Value: Run Hours
Engine operation hours counter. If an ECU is configured and it provides engine
hours value, the value is taken from ECU. If the value is not available from the
ECU or ECU is not configured, the engine hours are incremented in the controller
while the engine is running.
NOTE:
The counter can be readjusted/reset from InteliMonitor menu Monitor -> Set
statistics.
Value: Num starts
Engine start commands counter. The counter is increased by 1 even if the
particular start command will take more than one attempt.
NOTE:
The counter can be readjusted/reset from InteliMonitor menu Monitor -> Set
statistics.
Value: NumUnsc start
Unsuccessful starts counter. The counter is incremented always when Start fail
alarm is issued.
NOTE:
The counter can be readjusted/reset from InteliMonitor menu Monitor -> Set
statistics.
Value: Service time 1
To Next Page
Loading...
Need help?
General
