IGS-NT Combi, SW Version 3.0, ©ComAp – May 2013
IGS-NT-Combi-3.0 Reference Guide.PDF
NOTE:
See an example in the description of the binary input Force value 1.
Binary input: ForceValueIn 8
This input activates the Force value #8 block. If the input is active, the value of the
setpoint, to which the Force value #8 block is configured, will be overriden by
value of the alternative setpoint assigned to the Force value #8 block.
NOTE:
If there are more than one force value blocks configured onto one setpoint then
the highest priority has the block with the lowest index (i.e. the first active block
according to the list displayed in GenConfig in the Force value window at the
related setpoint).
NOTE:
Watch a training video about force value function here:
http://www.comap.cz/support/training/training-videos/.
NOTE:
See an example in the description of the binary input Force value 1.
Binary input: ForceValueIn 9
This input activates the Force value #9 block. If the input is active, the value of the
setpoint, to which the Force value #9 block is configured, will be overriden by
value of the alternative setpoint assigned to the Force value #9 block.
NOTE:
If there are more than one force value blocks configured onto one setpoint then
the highest priority has the block with the lowest index (i.e. the first active block
according to the list displayed in GenConfig in the Force value window at the
related setpoint).
NOTE:
Watch a training video about force value function here:
http://www.comap.cz/support/training/training-videos/.
NOTE:
See an example in the description of the binary input Force value 1.
Binary input: ForceValueIn10
This input activates the Force value #10 block. If the input is active, the value of
the setpoint, to which the Force value #10 block is configured, will be overriden by
value of the alternative setpoint assigned to the Force value #10 block.
NOTE:
If there are more than one force value blocks configured onto one setpoint then
the highest priority has the block with the lowest index (i.e. the first active block
according to the list displayed in GenConfig in the Force value window at the
To Next Page
Loading...
Need help?
General
