Maintenance
79
C2500CB-OM-EN-16
LPG Engine Oil & Filter Change Procedure
1. Park the truck in a designated service
area (ground must be level).
2. Lower the mast fully and tilt fully forward.
3. Switch off the engine and wait until all
parts are cool enough to touch.
4. If the engine is cold run it for 5 minutes
to warm the oil. This will help it to flow.
5. Open the bonnet from the right hand
side of the truck.
6. Remove the access panel (A) from the
right hand side of the truck.
7. Position a suitable waste oil collection
container (see point 18 for the volume of
oil in the engine) on the ground to the
right hand side of the engine.
8. Unclip the drain hose (B) from the right hand side of the radiator/oil cooler.
9. Unscrew the cap (C) from the oil drain fitting on the bottom of the engine and
screw the threaded end of oil drain hose on. Oil will only start to flow when the
hose is fully screwed on.
10. Direct the free end of the oil drain hose over the collection container.
11. Allow the oil to drain completely.
12. Unscrew the drain hose from the drain fitting, then screw on the cap and tighten.
Torque to 50 Nm (37 ft. lbs)
13. Clean down the drain hose the clip it securely in the p-clip on the side of the
radiator.
14. Unscrew and remove the used engine oil filter (D) (dispose of the used filter in
accordance with local environmental regulations) from the left hand side of the
engine. Use a filter wrench if required.
B
C
A
B
E
D
D
E
Toyota LPG
GM LPG
To Next Page
Loading...
