Maintenance
88
C2500CB-OM-EN-16
Draining the Cooling System:
1. Park the truck in a designated service
area with the forks lowered fully and the
mast tilted fully forward.
2. Switch off the engine and wait until the
radiator is cool enough to touch.
3. Open the bonnet from the right hand
side of the truck.
4. Remove the access panel from the right
hand side of the truck.
5. Remove the radiator cover panel (A)
from the rear of the truck.
6. Remove the cap (B) from the top of the
radiator.
7. Turn the cap anticlockwise gradually to
release any pressure before removing.
8. Place a suitable container behind the
truck under the drain plug (C) to collect
the used coolant.
9. Unscrew the drain plug and allow time
for the coolant to drain completely from
the radiator. Use a funnel or hose to
channel the used coolant into the
collection container
10. Empty the coolant bottle.
11. Open the coolant drain (F) on the right hand side of the engine. Use a funnel
or pipe to channel the used coolant into the collection container.
12. Allow time for the coolant to drain completely from the engine.
13. Close the drain on the engine.
(On the PSI GM LPG engine use a suitable high temperature
thread sealant when refitting the drain plug)
14. Refit the radiator drain plug with a new seal (D) and tighten into the radiator.
Torque to 94-98 Nm (70-72 ft. lbs)
A
B
Toyota LPG
PSI GM LPG
Kubota Diesel
F
F
F
To Next Page
Loading...
