Other Features GCA70-245
72 Comdial August, 03
7.3 Default Volume Control
When you change the loudness, that change remains in effect until
you change it again (referred to as default setting).
• Set the speaker, headset, handset, or group listening
loudness for all future calls using the following steps:
1. PRESS INTERCOM.
2. CHOOSE speaker, headset, handset, or group listen mode to be
affected.
3. While in that mode, PRESS VOLUME UP OR VOLUME DOWN to
adjust loudness.
4. DIAL **5 to hold the loudness at the last setting for all future calls
(until it is changed again).
5. REPEAT this procedure in each mode until all default volume levels
have been properly set.
NOTE: You may adjust the volume of a call in any mode (over
speaker, headset, handset or group listen), at any time during the
call, by pressing VOLUME UP or VOLUME DOWN.
When the call
ends, the volume of all future calls is reset to the programmed (default)
setting.
To Next Page
Loading...
